Vexes - D.00 Land - 4.990 (V) AC AC Figure 2 4.988 (V) Som the AC Votage 4) Change only the frequency To 180 Hz and repeat step 3 above. Double click the peak of the Output Voltage and then click the tool that becomes available or use the cursor button Record Vines from the multimeter and V. Then click "Stopo make the output stationary on the screen. 3) Click "Monitor" in Capstone and adjust your axis manually or with the auto-adjust tool 2. Figure! Connect the multimeter to the interface as shown in Figure 2 below. On the right side, drag and drop * "scope" display Select the y ti mesurement to be "Output Voltage" On the bottom-left, change the recording mode from Continuous Mode to Fast Monitor Mode. Also check the "Auto" button for output to automatically turn on when Monitor" is clicked later. On the left side, click Signal Generation" and select a Sine Wave with an amplitude of 5.0 V and a frequency of 60 H. On the left side, click Hardware Setup and select the power supply output voltage current sensor. AC Signals and the Oscilloscope: RMS and Peak Values Procedure Open Capstone software.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |